Branch Offices

From Vodia PBX Wiki
Jump to: navigation, search

Contents

Connecting Branch Offices Together

This section describes how to connect two snom ONE systems together so that calls between the two locations will be routed through VoIP rather than through the local PSTN. Two different scenarios are presented:

  • Two snom ONE telephone systems with public routable IP addresses (this model is also suitable for two systems on a private network with no NAT issues)
  • Two snom ONE telephone systems: A head office site and a remote site

Using a Gateway Trunk

SIP gateway trunks are the best method for connecting two snom ONE telephone systems, as long as both systems either have public routable IP addresses or are on a private network with no issues with NAT. Likely candidates for this configuration are the classroom environment and organizations with a large private network (as long as the system has an interface directly on a public IP address). The image below shows two remote sites connected by two gateways. Callers from either system can dial the other system using four-digit dialing.

Trunk-offices-1.png

Create a trunk for each branch office, using the instructions that are shown below.

Branch Office 1

  1. From the Type dropdown, select SIP Gateway.
  2. Enter the IP address into the Domain field:
Trunk-offices-3.png

Branch Office 2

  1. From the Type dropdown, select SIP Gateway.
  2. Enter the IP address into the Domain and Outbound Proxy fields:
Trunk-offices-2.png

Using a SIP Registrations Trunk (SIP Tie Line)

The SIP registration trunk can be used to connect two branch offices when one of the offices has a private IP address. For example, a corporate head office has a pubic IP address, and a remote branch office has only one public IP address and requires that the system be on a private address but still wants to have connectivity back to corporate.

Trunk-offices-4.png

Branch Office 2

  1. Create an extension that will be used by the trunk to route the calls:
Trunk-offices-5.png

Branch Office 1

  1. Create a SIP registrations trunk for the branch office, entering the extension that will be used to route the calls (e.g., 525).
Trunk-offices-6.png

Don't forget to set Trunk ANI to 525 in the trunk settings.

Once the offices have been connected, the headquarters will need to dial the extension that the trunk is routed to. Once the call hits the branch office, it will be sent to the auto attendant so that the headquarters can dial the remote extensions. The trunk has to register to the extension just as a phone would, so the system at the branch office will need to register the trunk to the system at the headquarters, the same way an ITSP would need to be registered. Then anyone in the world can dial the DID, much like they would dial that extension.

Calls from Site 1 to Site 2

To make calls from Site 1 to Site 2, you must add a dialplan to route, for example, all calls to 6xx through the "SIP Tie" trunk. Here is an example:

Dialplan 6xx.png
Calls from Site 2 to Site 1

To make calls from Site 2 to Site 1:

  1. Create an auto attandant on Site 1, for example with number 500.
  2. Send all calls coming through the "SIP Tie" trunk to number 500 (by setting "Send call to extension" to 500 in the trunk's settings).